Configuring D-Link Switches

Alteeve Wiki :: How To :: Configuring D-Link Switches

Validated Switches

The following switches (and firmwares) have been validates to work with the Anvil!:

• DGS-3130-series

Other models will be similar, but this is the tested model.

Serial Connection

Note: Depending on your terminal emulator, the <Backspace> key may not work. If it doesn't, try pressing ctrl + h to delete the character to the left of your cursor.

You can use screen to connect to the switch. The example below is what you would use on most servers with an on-board serial port. If you have two, then port two would be /dev/ttyS1. If you are using a USB to serial adaptor, then you will use /dev/ttyUSB0 (or if it is a multi-port adapter, /dev/ttyUSB1, etc). If none of these work, you will need to consult your operating system documentation and/or serial port adapter to determine the proper /dev/ttyX device to use.

screen /dev/ttyUSBO 115200

The screen will be blank until you press <enter>.

                 DGS-3130-30TS Gigabit Ethernet Switch

                          Command Line Interface
                            Firmware: 2.00.011
           Copyright(C) 2018 D-Link Corporation. All rights reserved.


Switch>

To log in;

Switch>enable

Switch#

There is no default user name and password.

Exiting screen

To end your screen session, press ctrl + a together, release and then press k.

You will be asked if you want to kill the session, press y to confirm.

Really kill this window [y/n]

[screen is terminating]

Configure an IP address

By default, the switch uses the IP address 10.90.90.90/8. If this is not accessible, you can change the IP address using the console.

Note: Super User level password can be an alphanumeric string, but cannot begin with a number.

Switch>enable

Switch#configure terminal 

Switch(config)#interface vlan 1

Switch(config-if)#ip address 10.201.1.3 255.255.0.0

Switch(config-if)#exit

Switch(config)#exit

Once this is set, connect to the Web interface to save the changes and/or make additional changes.

The default login username is admin and the default password is also admin.

 

Any questions, feedback, advice, complaints or meanderings are welcome.
Alteeve's Niche!	Alteeve Enterprise Support	Community Support
© 2025 Alteeve. Intelligent Availability® is a registered trademark of Alteeve's Niche! Inc. 1997-2025
legal stuff: All info is provided "As-Is". Do not use anything here unless you are willing and able to take responsibility for your own actions.