Configuring D-Link Switches
Validated Switches
The following switches (and firmwares) have been validates to work with the Anvil!:
- DGS-3130-series
Other models will be similar, but this is the tested model.
Serial Connection
 |
Note: Depending on your terminal emulator, the <Backspace> key may not work. If it doesn't, try pressing ctrl + h to delete the character to the left of your cursor. |
You can use screen to connect to the switch. The example below is what you would use on most servers with an on-board serial port. If you have two, then port two would be /dev/ttyS1. If you are using a USB to serial adaptor, then you will use /dev/ttyUSB0 (or if it is a multi-port adapter, /dev/ttyUSB1, etc). If none of these work, you will need to consult your operating system documentation and/or serial port adapter to determine the proper /dev/ttyX device to use.
screen /dev/ttyUSBO 115200
The screen will be blank until you press <enter>.
DGS-3130-30TS Gigabit Ethernet Switch
Command Line Interface
Firmware: 2.00.011
Copyright(C) 2018 D-Link Corporation. All rights reserved.
Switch>
To log in;
Switch>enable
Switch#
There is no default user name and password.
Exiting screen
To end your screen session, press ctrl + a together, release and then press k.
You will be asked if you want to kill the session, press y to confirm.
Really kill this window [y/n]
[screen is terminating]
Configure a Password
To use the web interface later, a user and password needs to be set.
|
Note: Super User level password can be an alphanumeric string, but cannot begin with a number. |
| Any questions, feedback, advice, complaints or meanderings are welcome. | |||
| Alteeve's Niche! | Enterprise Support: Alteeve Support |
Community Support | |
| © Alteeve's Niche! Inc. 1997-2024 | Anvil! "Intelligent Availability®" Platform | ||
| legal stuff: All info is provided "As-Is". Do not use anything here unless you are willing and able to take responsibility for your own actions. | |||